Toyota 7FB10, 7FBH10, 7FB14, 7FBH14 Forklift Service Repair Manual

This manual covers the inspection, adjustment and repair procedures mainly for the overhaul of the engine, chassis and material handling system of the TOYOTA ELECTRIC POWERED FORKLIFT 7FB-10 to 30 series and 7FBJ35.

For the service procedures of the mounted engine, read repair manuals listed below as reference together with this manual.

Table of content of the Repair Service Manual

GENERAL
BATTERY
CHARGER
CONTROLLER
MULTI-DISPLAY FUNCTIONS
ELECTRICAL SYSTEM TROUBLESHOOTING
MOTOR
DRIVE UNIT
FRONT AXLE
REAR AXLE
BRAKE
BODY
MATERIAL HANDLING SYSTEM
MAST
CYLINDER
OIL PUMP
OIL CONTROL VALVE
SAS FUNCTIONS (OPT)
APPENDIX
ATTENTIVE POINTS ON SAS
1. Read Section 18 SAS “Precautions for Repair” on Page 18-9 in this repair manual in advance.

2. Whenever the repair or replacement is performed to the place where relative to SAS function, resetting procedure by which the SAS regain proper function must be performed. (See Page 18-19)

3. The warning on the SAS caution label must be confirmed when the modification or change is such as to change the original specification.If improper, change the label. (See Page 18-1 0-1)
4. Care should always be exercised for safety operation whenever you operate the truck.
Make distinction between the SAS featured trucks and those of none, because the control features are different.

5. The SAS oil control valves comprise many precision valves. Since dirty or contaminated hydraulic oil will adversely affect the functions of these valves, always wash the parts clean at the time of installation after disassembly or for replacement of hydraulic parts (valves, piping, etc.). Periodic replacement of the hydraulic oil is very important.

6. Since this vehicle uses high-precision electronic devices, modification of electrical parts may cause faults. Always use genuine Toyota parts when replacing or installing electrical parts (auxiliary equipment, optional parts, etc.).