Takeuchi TB240 Service Repair & Parts Manuals PDF

Language of the Manual: English
Takeuchi TB240 Service Repair Manual – 456 Pages
Takeuchi TB240 Parts Manual – 178 Pages
Takeuchi TB240 Service Manual – 456 Pages
For All applicable S/N

The Takeuchi TB240 manual is intended for persons who engage in maintenance operations, and explains procedures for disassembly and reassembly of the machine, check and maintenance procedures, maintenance reference values, troubleshooting and outline specifications, etc. Please use this Takeuchi manual for excavator TB240 as a reference in service activities to improve maintenance techniques.

Please note that the contents and diagrams included in this manual may not match your machine exactly.

Items or diagram which manual contains are subject to change without notice due to design modifications, etc. Always store the Takeuchi excavator manual near at hand preferably on the machine itself. When transferring ownership of this machine, be sure to provide the owner manual to the next owner.

Table of Content of TB240 Instructions Manual:

I . GENERAL
II . SPECIFICATIONS
III. MACHINE CONFIGURATION
IV. HYDRAULIC UNITS
V . TROUBLESHOOTING
VI. ENGINE

Before operating, perform the prescribe inspections and make repairs immediately should any irregularities be found. If a failure that causes loss of control such as steering, service brakes or engine occurs, stop the machine motion as quickly as possible, follow the shutdown procedure, and keep machine securely park until the problem is fixed.

Extract from the Service Manual:
Disassembly and Assembly
The numbers in parentheses () listed after the names of parts in this document match the numbers used in the construction diagrams and parts lists.
General Precautions
Perform disassembly and assembly work in a clean place. Provide clean containers to hold parts during disassembly.
Clean around the ports before disassembly. Remove paint around connectors with a wire brush.
Clean the disassembled parts with wash oil.
Put alignment marks on all parts to reassemble them in the same positions.
After each disassembly, replace all seals and apply a thin layer of grease to them.
Check each part for abnormal wear or seizing. Remove any burrs with sandpaper.
Do not move adjusting screws, unless absolutely necessary.