Takeuchi TB045 Repair, Operator and Parts Manuals PDF

Takeuchi TB045 Service Repair Manual – 482 Pages
Takeuchi TB045 Operating Manual – 80 Pages
Parts Manual for TB045 – 247 Pages
Language of the Manual: English
Takeuchi TB045 Service Manual – 482 Pages

The Takeuchi TB045 manual is intended for persons who engage in maintenance operations, and explains procedures for disassembly and reassembly of the machine, check and maintenance procedures, maintenance reference values, troubleshooting and outline specifications, etc. Please use this Takeuchi manual for excavator TB045 as a reference in service activities to improve maintenance techniques.

Please note that the contents and diagrams included in this manual may not match your machine exactly.

Items or diagram which manual contains are subject to change without notice due to design modifications, etc. Always store the Takeuchi excavator manual near at hand preferably on the machine itself. When transferring ownership of this machine, be sure to provide the owner manual to the next owner.

Table of Content of TB045 Instructions Manual:

I . GENERAL
II . SPECIFICATIONS
III. MACHINE CONFIGURATION
IV. HYDRAULIC UNITS
V . TROUBLESHOOTING
VI. ENGINE

Before operating, perform the prescribe inspections and make repairs immediately should any irregularities be found. If a failure that causes loss of control such as steering, service brakes or engine occurs, stop the machine motion as quickly as possible, follow the shutdown procedure, and keep machine securely park until the problem is fixed.

Extract from the Service Manual:
4. Inspect the relief valve.
a. Set a pressure gauge in the pressure sensor port.
b. Operate the operation lever corresponding to the hydraulic system for that relief valve.
c. The valve is normal if the pressure gauge reading is the standard value.
(Refer to “II, Specifications, Standards for Judging Performance”.)
I f the relief valve’s set pressure is too low, adjust it by tightening the relief valve set screw gradually.
Caution
If the pressure doesn’t rise after 1/4 turn of the screw, the relief valve is faulty.
Cautions During Disassembly and Reassembly The dimension A of the set screw should be measured and recorded when the cap nut is removed.
Inspect for biting of foreign matter and for scratches in the poppet seat surface.

During assembly, the set screw should be set so that dimension A , measured before disassembly, is a little longer than previously. Then the screw should be tightened gradually to adjust the pressure.