Mitsubishi FBC15K, FBC18K, FBC18KL Forklift Lift Truck Repair Manual

Mitsubishi FBC15K, FBC18K, FBC18KL Forklift Service Manual: 230 Pages
Controller Manual: 154 Pages
Publication 99759-74120
English
Mitsubishi FBC15K, FBC18K, FBC18KL Lift Truck Manual
Lift Truck Forklift Model: FBC15K, FBC18K, FBC18KL

Forklift Manual Table of Content:

General Information
Front Axle & Reduction Differential
Transfer Assembly
Rear Axle
Brake System
Steering System
Hydraulic System
Mast and Forks
Troubleshooting Section
Maintenance Service Data
This service manual deals with all components or systems of the Mitsubishi Forklift Trucks, except for the electrical system, which is covered in a Controller manual
Tie Rods and Pins
Kingpins
Check the kingpins for any surface flaws such as grooving or stepped wear. Inspect the pins for cracks at the bearing shoulder.
Kingpin Bearings
Examine the rollers and bearing races for grooving, abrasive wear, pitting, bruising, or corrosion.
Replace both the cup and cone of damaged bearings.
Knuckles
Inspect the inside of each knuckle for wear or damage. Be sure to examine for casting cracks.
Check the tie rod pin hole. Examine the wheel nut threads for damage.
Cylinder Rod
Examine the rod for surface or plating damage.
Inspect the rod for straightness. Examine the piston for damage. Check the tie rod pin hole for damage or wear.
Seals and O-rings
Examine all seals and O-rings for damage such as cuts and tears. Replace seals which show signs of aging.
Hydraulic Pipes
Inspect the hydraulic pipes for cracks, especially at the joints with the end fittings. Check for leaks.
Tires
Check the height of the solid rubber portion and, if worn down to 25.4 mm (1 in.), replace the tire.