Massey Ferguson 2605, 2615 Tractor Repair Service Manual

Table of Contents

Massey Ferguson 2605, 2615 Manual

Main sections and selected subjects identified in the source documentation:

• Model: Tractor 2605, 2615
• Type: Workshop Repair Manual
• Manual for Tractor 2605, 2615
• Type: Workshop Service Manual
• Extract of the Manual Procedure for Eliminating Air from Fuel system (SJ327E with VE type Fuel Pump)
• Following procedure describes eliminating air from the fuel line system in SJ 327 E engine fitted with MICO VE
• type fuel injection pump applicable to tractors
• Ensure diesel flows freely at feed pump inlet and tighten the banjo bolt.
• Operate hand primer
• Release air at vent screw from primary bowl of fuel filter. Ensure fuel flows without air and tighten the vent screw.
• Release air at vent screw from secondary bowl of fuel filter. Ensure fuel flows without air and tighten the vent screw
• Then loosen the three nuts of high pressure fuel pipe at atomiser.
• Crank the engine with the help of battery until fuel flows free of air.
• Tighten the three nuts of high pressure pipe at atomiser.
• Engine is now ready to start.
• 7B – 12 DIFFERENTIAL CARRIER ASSEMBLY
• Removal and refitment
• Removal
• Secure the tractor by applying the parking brake.
• Jack up the front of the tractor and support under the engine.
• Slide back the propeller shaft guard and disconnect the propeller shaft.
• Remove the axle from the tractor, see operation 7B – 5.
• Remove both front wheels.
• Drain the oil from the axle housing.
• Remove both swivel housings, see operation 7B – 9 .It is not necessary to dismantle the planetary hubs.
• Remove the steering ram, see operation 7B – 16.
• Remove the ten bolts holding the differential carrier to the axle casing.
• WARNING: Take care when removing the differential carrier assembly, it is uncomfortable and heavy to handle.
• The differential is located by dowels in the axle casing. Carefully pry it away from the axle housing supporting the weight at all times.
• Refitment
• Reverse procedures 1 to 10 except: a. Apply Massey Ferguson Instant Gasket (Loctite 596) to the joint face of the differential case.
• b. Apply loctite 118 to the differential carrier bolts and tighten them to a torque of 95 – 103 lbf.ft (130 – 140 Nm)