Manitou MRT-X 2150, 2550 Privilege Plus ST3A S2 Telehandler Repair Manual

Telehandler Applicable Model:
MRT-X 2150 PLUS-ST3A S2
MRT-X 2550 PLUS-ST3A S2
Manitou MRT-X 2150, 2550 Privilege Plus ST3A S2 Telehandler Repair Service Manual – 1929 Pages
Manitou MRT-X 2150 PLUS-ST3A S2 Part Catalog – 900 Pages
Manitou Dana Axle Type 213 Repair Manual – 116 Pages
Manitou Air Heater Independently (Airtronic/ Airtronic M) Manual – 70 Pages
Manitou HydroStatic Pump H1 060/080/110/160/250 Manual – 76 Pages
Manitou Transfer Box Type 357 Manual – 52 Pages

Table of content of the Repair Manual:

GENERAL
ENGINE
TRANSMISSION
AXLE
BRAKE
BOOM
HYDRAULIC
ELECTRICITY
DRIVER’S CAB
FRAME – BODY
OPTIONS – ATTACHMENTS
Any non-compliance increases the risk of accidents occurring which may lead to causing grievous bodily
harm and even death. An efficient, dependable and profitable combination will be formed if the operator follows the safety
manual correctly and the machine is serviced properly.

The efficiency and continued operation of mechanical units depend on constant, correct maintenance and also on efficient repair work, should there be a break-down or malfunction. The instructions contained in this Manitou MRT-X 2150, 2550 Privilege Plus ST3A S2 Telehandler repair manual have been based on a complete overhaul of the unit. However, it is up to the mechanic to decide whether or not it is necessary to assemble only individual components, when partial repair work is needed. The manual provides a quick and sure guide which, with the use of photographs and diagrams illustrating the various phases of the operations, allows accurate work to be performed.The coverage below addresses disassembly, checks and assembly of components. In order to remove the differential unit from the vehicle, the manuals provided by the vehicle manufacturer should be consulted. In describing the following operations it is presumed that the unit has already been removed from the vehicle.

INTRODUCTORY REMARKS: All the disassembled mechanical of the MRT-X 2150 PLUS-ST3A S2, MRT-X 2550 PLUS-ST3A S2 should be thoroughly cleaned with appropriate products and restored or replaced if damage, wear, cracking or seizing have occurred. In particular, thoroughly check the condition of all moving parts (bearings, gears, crown wheel and pinion, shafts) and sealing parts (o-rings, oil shields) which are subject to major stress and wear. In any case, it is advisable to replace the seals every time a component is overhauled or repaired. During assembly, the sealing rings must be lubricated on the sealing edge. In the case of the crown wheel and pinion, replacement of one component requires the replacement of the other one. During assembly, the prescribed pre-loading, backlash and torque of parts must be maintained.