Manitou MHT 10230 Mining 129M ST4 S1, MHT-X 10230 Mining 129M ST3A S1 Telehandler Repair Manual

Format: PDF

Language: English

Manitou Telehandler Applicable Model:

MHT 10230 Mining 129M ST4 S1

MHT-X 10230 Mining 129M ST3A S1

Manitou MHT 10230 Mining 129M ST4 S1, MHT-X 10230 Mining 129M ST3A S1 Telehandler Repair Manual – 832 Pages

Manitou Omci Axles Type 372 Repair Manual – 64 Pages

Axial Pistion Variable Motor A6VM- 76 Pages

Manitou RadioControl Autec Series Dynamic Plus Manual – 286 Pages

Manitou MHT 10230 Mining 129M ST4 S1, MHT-X 10230 Mining 129M ST3A S1 Telehandler Repair Manual

Format: PDF

Language: English

Manitou Telehandler Applicable Model:

MHT 10230 Mining 129M ST4 S1

MHT-X 10230 Mining 129M ST3A S1

Manitou MHT 10230 Mining 129M ST4 S1, MHT-X 10230 Mining 129M ST3A S1 Telehandler Repair Manual – 832 Pages

Manitou Omci Axles Type 372 Repair Manual – 64 Pages

Axial Pistion Variable Motor A6VM- 76 Pages

Manitou RadioControl Autec Series Dynamic Plus Manual – 286 Pages

Table of content of the Repair Manual:

GENERAL

ENGINE

TRANSMISSION

AXLE

BRAKE

BOOM

HYDRAULIC

ELECTRICITY

DRIVER CAB

FRAME – BODY

This section contains general instructions and notes on safety for inspection and maintenance tasks.

Differential Component Excerpt

The following excerpt concerns work on a differential unit. However, it is up to the mechanic to decide whether or not it is necessary to assemble only individual components, when partial repair work is needed. In order to remove the differential unit from the vehicle, the manuals provided by the vehicle manufacturer should be consulted. In describing the following operations it is presumed that the unit has already been removed from the vehicle.

INTRODUCTORY REMARKS: All the disassembled mechanical of the MHT 10230 Mining 129M ST4 S1, MHT-X 10230 Mining 129M ST3A S1 should be thoroughly cleaned with appropriate products and restored or replaced if damage, wear, cracking or seizing have occurred. In particular, thoroughly check the condition of all moving parts (bearings, gears, crown wheel and pinion, shafts) and sealing parts (o-rings, oil shields) which are subject to major stress and wear. In any case, it is advisable to replace the seals every time a component is overhauled or repaired. During assembly, the sealing rings must be lubricated on the sealing edge. In the case of the crown wheel and pinion, replacement of one component requires the replacement of the other one. During assembly, the prescribed pre-loading, backlash and torque of parts must be maintained.