Kubota U17, U17-3 Excavator Repair Service Manual

Table of Contents

Kubota U17, U17-3 Manual

Main sections and selected subjects identified in the source documentation:

• Kubota Excavator Model U17, U17-3
• I General
• II Machine body
• Mechanism Section . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .II-M-1
• Service Section . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .II-S-1
• III Engine
• Mechanism Section . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .III-M-1
• Service Section . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .III-S-1
• IV Hydraulic System
• Mechanism Section . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .IV-M-1
• Service Section . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .IV-S-1
• ELECTRICAL SYSTEM
• Mechanism Section . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . V-M-1
• Service Section. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . V-S-1
• U17, U17-3
• IMPORTANT INSPECTION ITEMS AFTER REASSEMBLING
• a Operate the Kubota U17, U17-3 Excavator and check for Unusual Noise and Vibrations.
• b Make Sure the Safety decals and Wire harness Clamps are in their Specified Positions.
• 1) Park the machine on a level ground.
• 3) Keep the machine front as shown as following posture.
• Checking Radiator Hoses and Clamp Bands
• Check to see if the radiator hoses are properly fixed every 200 hours of operation or every six months, whichever comes first.
• If the clamp is loose, apply oil to the threads and retighten it securely.
• The water hose is made of rubber and tens to age. It must be replaced every two years. Also replace the clamp and tighten it securely.
• W1029518
• Checking Intake Air Line
• Check to see if the intake air hose(s) (1) and the breather hose (3) are properly fixed every 200 hours of operation.
• If the clamp (2) is loose, apply oil to the threads and retighten it securely.
• The intake air hose(s) (1) and the breather hose (3) are made of rubber and tends to age. It must be changed every two years.
• Also change the clamp (2) and tighten it securely.
• IMPORTANT To prevent serious damage to the engine, keep out any dust inside the intake air line.