Kubota G23, G26 Mowers Repair Manual

Kubota Mower Model G23, G26
Kubota G23, G26 Mower Workshop Service Manual

Table of Content of the Mower G23, G26 Workshop Service Manual

This Workshop Manual tells the servicing personnel about the mechanism, servicing and maintenance of the G23 and G26. It contains 4 parts: “Information”, “General”, “Mechanism” and “Servicing”.

– Information
This section contains information below.
Safety First
Safety Label
Dimension
– General
This section contains information below.
Engine Identification
Model Identification
General Precautions
Maintenance Check List
Check and Maintenance
Special Tools
– Mechanism
This section contains information on the structure and the function of the unit. Before you continue with the subsequent sections, make sure that you read this section.
Refer to the latest version of Workshop Manual (Code No. 9Y021-01870) for the diesel engine mechanism that this workshop manual does not include.
– Servicing G23, G26 Mowers
This section contains information below.
Troubleshooting
Servicing Specifications
Tightening Torques
Checking, Disassembling and Servicing
Replacing Engine Oil Filter
CAUTION
To avoid personal injury :
Be sure to stop the engine and remove the key before changing the oil and the oil filter.
Allow engine to cool down sufficiently; oil can be hot and may cause burns.
1. Remove the oil filter.
2. Put a film of clean engine oil on the rubber seal of the new filter.
3. Tighten the filter quickly until contacts the mounting surface.
Tighten filter by hand an additional 1/2 turn only.

4. After new filter has been replaced, the engine oil normally decreases a little. Make sure that the engine oil does not leak through the seal and be sure to check the oil level on the dipstick. Then, replenish the engine oil up to the prescribed level.

5. Properly dispose of used oil.