Overview
The Komatsu WA150-6 wheel loader repair service manual provides a technical reference for the covered equipment. Its purpose is to help locate information relevant to inspection, troubleshooting, servicing and repair, as applicable to the supplied publication.
The documented contents outline identifies manuals: shop manual, index and foreword, specification and structure, functions and maintenance standard. The table below lists selected source-supported subjects; consult the publication for exact service procedures and specifications.
Important Information: Confirm the applicable serial-number or production range in the supplied documentation before selecting a procedure.
Table of Contents
Komatsu WA150-6 Manual
Main sections and selected subjects identified in the source documentation:
- Manuals: Shop Manual
- Index and Foreword
- Specification
- Structure, functions and maintenance standard
- Standard value table
- Testing and Adjusting
- Troubleshooting
- Disassembly and Assembly
- Appendix
- Diagrams and drawings
- Manual Extract Bleeding air from fuel circuit
- If fuel is used up or if a fuel circuit part is removed and installed, bleed air from the fuel circuit according to the following procedure.
- Put chocks under the tires securely.
- When measuring, check that there are no persons around the machine.
- Fill the fuel tank with fuel.
- Open the right side cover of the engine.
- Remove fuel pre-fuel filter (1) and fill it with fuel.
- Fill the fuel filter with clean fuel and take care that dirt will not enter it.
- After filling the pre-fuel filter with fuel, remove the cap from part (a).
- If clean fuel is not available, do not remove the pre-fuel filter but fill it with the fuel by operating priming pump (2).
- Do not add fuel to fuel main filter externally.
- Install pre-fuel filter (1) to the filter head.
- Apply engine oil thinly over the packing on the pre-fuel filter side.
- After the packing of the pre-fuel filter touches the sealing face of the filter head, tighten the fuel filter 3/4 turns.
- Loosen air bleeding plug (4) of the fuel main filter bracket and operate priming pump (2).
- Operate the priming pump until fuel flows out of the plug hole. After checking that fuel flows out, tighten the plug (4).
- Confirm that air does not coexist in fuel. 3Air bleeding plug (4): 7.8 – 9.8 Nm {0.8 – 1.0 kgm}
- Push the knob of the priming pump, and fix it.
- Start the engine with the starting motor.
- a The air in the high-pressure circuit is bled automatically if the engine is cranked.
- a If the engine does not start, there may be still air in the low-pressure circuit. In this case, repeat the above procedure from step 5.
Serial-Number Applicability
The covered production ranges or serial groups may affect the applicable procedures. Check the identification details on the machine against the source documentation.










Reviews
There are no reviews yet.