Hitachi Zaxis ZX19-6 Mini Excavator Service Repair Manual

Excavator Model: ZX19-6
English
Hitachi Zaxis ZX19-6 Mini Excavator Service Manual consists of the following separate Part No.
Technical Manual : Vol. No.TABL50-EN (342 Pages)
Workshop Manual : Vol. No.WABL50-EN (481 Pages)
Engine Manual : Vol. No.EABA-EN (243 Pages)
Operator’s Manual: Vol. No.ENMABL-EN (296 Pages)
Parts Catalog – 206 Pages

Manual Table of Content:

Workshop Manual Covers:

SECTION 1 -GENERAL

Group 1 – Precautions
Group 2 – Tightening
Group 3 – Painting
Group 4 – Bleeding Air
Group 5 – Preparation
Group 6 – Connect the Hose
SECTION2 -MAINTENANCE STANDARD
Group 1 -Upperstructure
Group 2 -Undercarriage
Group 3 – Front Attachment

SECTION 3 – UPPERSTRUCTURE

Group 1 – Cab
Group 2 – Counterweight
Group 3 – Main Frame
Group 4 – Pump Device
Group 5 – Control Valve
Group 6 – Swing Device
Group 7 – Pilot Valve
Group 8 – Solenoid Valve

SECTION 4 – UNDERCARRIAGE

Group 1 – Swing Bearing
Group 2 – Travel Device
Group 3 – Center Joint
Group 4 – Track Adjuster
Group 5 – Front Idler
Group 6 – Lower Roller
Group 7 – Track
Group 8 – Blade Cylinder
Group 9 – Side Frame Extend/Retract Cylinder

SECTION 5 – FRONT ATTACHMENT

Group 1 – Front Attachment
Group 2 – Cylinder
Precautions for Disassembling the ZX19-6 Excavat0r

Clean the Machine: Thoroughly wash the machine before bringing it into the shop. Bringing a dirty machine into the shop may cause machine components to be contaminated during disassembling / assembling, resulting in damage to machine components as well as decreased efficiency in service work.

Inspect the Machine: Be sure to thoroughly understand all disassembling / assembling procedures. This helps prevent incorrect disassembling and unnecessary purchase of parts.Check and record the following items. prevent problems from occurring in the future.

The machine model, machine serial number, and hour meter reading.
Reason for disassembly (symptoms, failed parts, and causes).
Clogging of filters and oil, water, or air leaks, if any. Capacities and condition of lubricants.
Loose or damaged parts.
Prepare and Clean Tools and Disassembly Area: Prepare the necessary tools to be used and the area for disassembling work. Then thoroughly clean them.