Hino FA4J FB4J 2004 Truck Workshop Manual PDF

This is the Repair and Service Manual for Hino Truck 2004

Series: FA, FB, FD, FE and SG

This workshop manual has been prepared to provide information covering repairs on FA, FB series Hino 2004 trucks.

General Introduction

Engine

Clutch

Clutch Control

Transmission

Transmission Control

Propeller Shaft

Rear Axle

Front Axle

Steering

Service Brake

Parking Brake

Exhaust Brake

Wheels & Tires

Suspension

Chassis Frame

Cab

Electrical Equipment

Alternator

Starter

Compressor

Turbocharger

Spring Brake

Power Steering

Automatic Transmission

Antilock Brake System

Total Electronics System

Service Specification

Electrical Wiring Diagrams

Hino Truck 2004 Manual Instruction Extract:INSPECTION

1. CHECK THE OPERATION OF THE ENGINE STOP MOTOR AND MECHANICAL

SWITCH.

WARNING

When the engine stop cover is removed, do not touch the cable or pulley with your hands, even when the key switch is in the “ACC” or “OFF” (LOCK) positions.

Check the motor only after removing the connector to the battery to avoid injury to your hands.

1. Devise a circuit as shown in Fig. 8.

2. Turn the switch on to rotate the motor. Then confirm that the motor stops at the point where the cable spring moves to the “in use” position.

3. The motor and the mechanical switch are both operating normally if when the switch is turned off, the motor rotates and stops at the point where the cable spring moves to the “stop” position.

2. IF THE ENGINE DOES NOT STOP WHEN THE STARTER SWITCH IS IN THE “OFF” POSITION, DO THE FOLLOWING.

1. Turn the starter switch to the “ON” position.

2. Open the front panel.

3. Disconnect the engine stop motor connector.

4. Remove the engine stop motor cover.

5. Pull the engine stop cable in the direction of the arrow until the engine stops.

6. When the engine stops re-install the engine stop motor cover.

7. Reconnect the engine stop motor connector.

8. Put the starter switch in the “LOCK” position.