Hino 155 155h 195 195h 2016 COE HEV Service Manuals PDF

Hino 2016 COE HEV Truck Manual for 155, 155h, 195, 195h Series – 857 Pages
Hino 2016 COE HEV Troubleshooting Manual – 871 Pages
Hino J05E Engine Manual – 653 Pages
This is the Repair and Service Manual for Hino Truck 2016 COE HEV
Applicable for HINO 155, 155h, 195, 195h series,
This workshop manual has been prepared to provide information covering repairs on 155, 155h, 195, 195h Series Hino 2016 COE HEV trucks.
To use Hino Year 2016 and Series 155, 155h, 195, 195h Conventional trucks for years, smoothly, safely, and economically without trouble, it is important to perform inspections.

Maintenance required to be performed is the responsibility of the owner. Some recommended repairs of your truck are mentioned. When making any repair of your truck, be careful not to be injured through improper procedures.

As for maintenance items, refer to the Owners and Drivers Manual. All information and specifications in this manual are based upon the latest product information available at the time of printing.

Table of Content For Hino 2016 COE HEV Truck Manual:

General Introduction
Engine
Hybrid System
Transmission
Clutch
Propeller Shaft
Axle
Differential
Brake
Steering
Frame and Frame Accessory
Cab Mounting and Cab Suspension
Body Construction
Suspension
Body Inside Accessory
Body Outside Accessory
Air Bag and Seat Belt
Heater and Air Conditioner
Electrical
Control System
Hino Truck 2016 COE HEV Manual Instruction Extract:
REPLACEMENT
REMOVING THE FRONT FLEXIBLE HOSE
2. REMOVING THE FRONT WHEELS
3. REMOVING THE FLEXIBLE HOSE No.1 (1) Using the union nut wrench (10 mm {0.394 in.}), disconnect the brake tube from the flexible hose No.1.
(2) Remove the clip and remove the flexible hose No.1 from the body.
(3) Remove the bolt and disconnect the flexible hose No.1 from the bracket.
(4) Unfasten the union bolt and gasket (2 pcs.) to remove the flexible hose No.1 from the brake caliper.
INSTALLING THE FRONT FLEXIBLE HOSE
1. INSTALLING THE FLEXIBLE HOSE No.1 (1) Install the flexible hose No.1 to the bracket with a new clip.
(2) Using the union nut wrench (10 mm {0.394 in.}), connect the brake tube to the flexible hose No.1.
Tightening Torque: 15 Nm {153 kgfcm, 11 lbfft}
! CAUTION
Install in a way that the twist of the flexible hose is minimum.
Install the clip certainly to the end.
(3) Connect the flexible hose No.1 to the brake caliper with the union bolt and new gasket (2 pcs.).
Tightening Torque: 31 Nm {316 kgfcm, 23 lbfft}
(4) Install the flexible hose No.1 to the bracket with a bolt.
Tightening Torque: 28 Nm {286 kgfcm, 21 lbfft}
2. BLEEDING AIR FROM THE BRAKE SYSTEM Reference: BRAKE, BRAKE CONTROL, BRAKE FLUID, REPLACEMENT, CHANGING THE BRAKE FLUID (Page 9-20) 3. INSTALLING THE FRONT WHEELS
Tightening Torque: 440-590 Nm {4,500-6,000 kgfcm, 325-435 lbfft}