Fendt 1149MT, 1154MT, 1159MT, 1165MT Rubber Track Tractor Workshop Manual

Fendt 1149MT, 1154MT, 1159MT, 1165MT Tractor Workshop Manual : 2748 Pages
Fendt 1149MT, 1154MT, 1159MT, 1165MT Tractor Operators Manual : 372 Pages
Book Number: 79037288C
English
Issued October 2018
Manual for: AGCO Fendt

Workshop Manual TABLE OF CONTENTS

General
Engine, Fuel and exhaust
Steering System
Drive Train System
Compressed Air System
Hydraulic System
Electrical System
Cab
Air conditioning and Heating System
Chassis
Track belt system
Implement Drive System
Implement Lift System
Attachments
Diagrams
Special Tools
Index
Manual Extract – Fault Code
Code SA 03 SPN 521469 FMI 02
Steering motor speed sensor 1 signal is not correct.
Diagnosis and solution
1. Check the sensor adjustment.
a) Turn the key start switch to the off position.
b) Turn the battery disconnect switch to the off position.
c) Remove the key from the battery disconnect switch.
d) Remove the speed sensor.
e) Clean the sensor and the mounting hole.
f) Install the sensor.
g) Turn the battery disconnect switch to the on position.
h) Turn the key start switch to the on position.
i) Operate the engine at low idle.
j) Check for active diagnostic codes.
Result
Expected result – SPN 521469 FMI 02 is not active.
Results:
Yes – SPN 521469 FMI 02 is not active.
Stop.
No – SPN 521469 FMI 02 is active.
2. Check the return circuit.
a) Turn the key start switch to the off position.
b) Turn the battery disconnect switch to the off position.
c) Remove the key from the battery disconnect switch.
d) Disconnect the speed sensor from the harness.
e) Check resistance from connector contact 2 to frame ground.
Result
Expected result – resistance is less than 5 ohms.
Results:
Yes – resistance is less than 5 ohms.
No – resistance is not less than 5 ohms.
Repair or replace the harness.