Challenger MT745D, MT755D and MT765D Rubber Track Tractor Workshop Manual Bundle

Challenger MT745D, MT755D, MT765D Tractor Workshop Manual : 3379 Pages
Challenger MT745D, MT755D, MT765D Tractor Repair Schedule Manual : 738 Pages
Manual for: AGCO Challenger MT900E Series Tractor
Book Number: 79035068 & 558752D1A
English
Issued June 2013
Manual for: AGCO Challenger MT700D Series Tractor

MT700D Series Manual TABLE OF CONTENTS

Introduction
Engine
Powertrain
Frame
Steering and Brake System
Implement and Three point Hitch Hydraulics System
Electrical
Air System
Virtual Terminal
Cab
Heating Ventilation and Air Conditioning
Ballasting
Appearance Group
Electronics
MT745D, MT755D, MT765D Manual Extract
Steering Servo Valve Testing
Introduction

The pump deadband is the pressure that is necessary to counteract the control springs. This is also the pressure that is necessary to begin to upstroke the pump. The pressure can be higher in one direction or in the other direction by the use of the neutral adjusting screw.

The total deadband is not adjustable, but the band can be adjusted to a neutral position.

The test is performed on the machine to check the position of the servo for the steering system. The test will show if the servo valve requires adjustment or the deadband requires adjustment.

Perform this test if one of the following conditions exist: • The steering pump upstrokes while the transmission control lever is in the PARK position.
The transmission control lever is in the PARK position. The belts turn while the machine is in a raised position.
If the following conditions occur, an electrical problem exists in the steering system:
The steering pump only upstrokes when the transmission control lever is in the NEUTRAL position.
The belts only turn while the machine is in a raised position. The transmission control lever is in the NEUTRAL position.
If necessary, calibrate the steering wheel first.