Challenger MT745C, MT755C and MT765C Rubber Track Tractor Workshop Manual

Manual for: AGCO Challenger MT700C Series Tractor
Book Number: 79033093
English
Issued September 2016

MT900E Series Manual TABLE OF CONTENTS

INTRODUCTION
ENGINE
POWERTRAIN
FRAME
STEERING AND BRAKE SYSTEM
IMPLEMENT AND THREE-POINT HITCH HYDRAULIC SYSTEMS
ELECTRICAL SCHEMATICS
AIR SYSTEM
VIRTUAL TERMINAL
Electrical System
CAB
HEATING VENTILATION AND AIR CONDITIONING
BALLASTING
APPEARANCE GROUP
ELECTRONICS
MT745C, MT755C, MT765C Manual Extract
| Event Identifier (EID) / Warning
Level
| Message on Main Display
| Description of Event
| 449-1
Leaving Seat With Electro-Hydraulic
(E/H) Implements Engaged
| HYDRAULIC ENGAGEMENT
HYD ACTIVE, OPERATOR
ABSENT
USE CAUTION

| Status of Implements and status of operator seat switch are monitored. If implements are engaged and operator leaves seat, a warning will occur. If any implement is engaged and operator seat switch indicates that seat is not occupied, a Warning

Level 1 will occur. This event will remain active until condition no longer exists.
| 452-3
Inch Pedal Sensor/Switch Fault
Warning
| INCH PEDAL SENSOR/SW FAULT
WARNING

| This event warns operator when a fault occurs with inch pedal sensor / switch. When condition is met, a Warning Level 3 will occur. This event will remain active until condition is no longer met for a specified period of time. This event cannot be snoozed.

| 627-2
Park Brake Engaged While Moving
| PARK BRAKE ENGAGED WHILE
MOVING
POTENTIAL PARK BRAKE
DAMAGE MAY OCCUR
| Park Brake Engaged While Moving.
Operator applied parking brake while machine is moving at a speed greater than 2.41 km/h (1.5 mph).
This message is displayed to warn operator that his action may damage parking brake system and he should avoid doing this in future operation.