Challenger MT515E, MT525E, MT535E and MT545E Tractor Workshop Manual Bundle

Challenger MT515E, MT525E, MT535E, MT545E Tractor Workshop Manual : 3455 Pages
Technician Service Book MT500E (Schematics and Electronics) : 814Pages
Parts Catalog MT500E AutoPower VI, TechStar CVT: 366 Pages & 424 Pages
Challenger MT515E, MT525E, MT535E, MT545E Tractor Repair Workshop Manual
Manual for: AGCO Challenger
MT500E AutoPower IV Series
MT500E AutoPower VI Series
MT500E TechStar CVT Series
North America – English
February 2015
No. ACT0009250

Challenger MT500E Series Manual TABLE OF CONTENTS

Introduction
Separation of assemblies
Engine
Clutch
Gearbox
Rear Axle
Power Take off
Front Axle
Hydraulics
Electricity
Electronics
Operator Environment
Accessories
Services Tools
MT515E, MT525E, MT535E, MT545E Manual Extract – Power Take off
The housing fitted to the rear of the “HA180” rear axle contains all the components of the rear PTO function.
The rear PTO can be divided into several sections: – The clutch
The clutch is located on the PTO upper shaftline and at the front of the PTO housing.
– The upper shaftline
The upper shaftline is equipped with a shaft and two gears which transmit the movement coming from the clutch to the driven gears.
– The lower shaftline
The lower shaftline receives the movement from the upper shaftline and transmits it to the implement via the intermediary of an output shaft.
The output shaft is fitted with an interchangeable end fitting which may be: – of varying length
– fitted with 6, 20 or 21 splines.
– The brake
The rear PTO is equipped with a brake located behind the clutch piston.
When the PTO is not engaged, the brake is actuated by the clutch piston, which is maintained under pressure by the spring washers.
– The controls
The controls are controlled by the solenoid valves located at the rear of the PTO housing.
When the controls are not supplied, they return mechanically to neutral position.
Lubrication of the rear PTO components
– The clutch and the upper shaftline
The rear PTO driveshaft carries the lubrication oil under pressure to the upper shaftline and the clutch through the internal lines.
The oil flow rate is controlled by a nozzle located at the entrance to the upper shaft and four restrictors located in the internal lines of the upper shaft.
– The lower shaftline
Lubrication is provided by splashing from moving parts and a jet of oil. The jet of oil is directed toward the shaft’s internal line.