Challenger MT455E, MT465E and MT475E Tractor Workshop Manual Bundle

Challenger MT455E, MT465E, MT475E Tractor Workshop Manual : 1376 Pages
Technician Service Book MT400E (Schematics and Electronics) : 646 Pages
Spicer Dana 740, 735 Axle Service Manual: 176 Pages & 176 Pages
Challenger MT455E, MT465E, MT475E Tractor Repair Workshop Manual
Manual for: AGCO Challenger MT400E Series Tractor
Book Number: ACT0026660
English
Issued May 2016

Challenger MT400E Series Manual TABLE OF CONTENTS

Introduction
Separation of assemblies
Engine
Clutch
Gearbox
Rear Axle
Power Take off
Front Axle
Hydraulics
Electricity
Electronics
Operator Environment
Accessories
Services Tools
MT455E, MT465E, MT475E Manual Error Code
| Err 14
| See error message 17/18
| Err 15
| The maximum front or rear transmission ratio has not been reached.
| Repeat
| Repeat calibration.
| If nec
| If necessary, check the efficiency of the hydrostatic system.
| Err 50
| Calibration is interrupted by the user with the
| Err 51
| Speed is above 0,1 km/h
| Err 52
| The engine speed is lower than 1400 rpm.
| Err 53
| The hand brake is not applied.
| Err 54
| The signal from the X8 – Bevel gear theoretical speed sensor is incorrect.
| Err 55
| The signal from the X8 – Bevel gear theoretical speed sensor is incorrect.
| Err 56
| The signal from the X25 – Engine speed sensor is incorrect.
| Err 57
| Clutch pedal sensor: The pedal is not pressed.
| Err 58
| Clutch pedal sensor is faulty.
| Err 59
| High/low speed range (Hare/Tortoise) shift switch has been activated.
| Err 60
| High/low speed range (Hare/Tortoise) shift switch is faulty.
| Err 61
| High/low speed range (Hare/Tortoise) shift switch has been activated.
| Err 62
| High/low speed range (Hare/Tortoise) shift switch is faulty.
| Err 63
| The range position sensor is not in neutral due to the calibration of the range position sensor.
| Err 64
| Electrical fault with X11 – Solenoid valve limiting speed to 30 km/h