CAT EC25K, EC25KE, EC25KL, EC30K, EC30KL Forklift Lift Truck Repair Manual

CAT EC25K, EC25KE, EC25KL, EC30K, EC30KL Forklift Service Manual: 200 Pages
Operation and Maintenance Manual: 121 Pages
Controller Manual: 135 Pages
Publication 99759-84120
English
Caterpillar CAT EC25K, EC25KE, EC25KL, EC30K, EC30KL Lift Truck Manual
Lift Truck Forklift Model: EC25K, EC25KE, EC25KL, EC30K, EC30KL

Forklift Manual Table of Content:

General Information
Front Axle
Transfer Assembly
Rear Axle
Brake System
Steering System
Hydraulic System
Masts and Forks
Troubleshooting
Maintenance Service Data

During truck start up or operation, a diagnostic code could appear on the display instead of the battery state of charge. If the GE SX Control System detects a problem, the ! symbol glows in the monitoring system action lights at the same time. The codes indicate an improper operating sequence or a defect in the truck electrical system.

Run-time diagnostics cover the following areas of truck operation and protection: • Drive motor and pump motor hours • Service reminder hours
Battery discharge level
Motor brush wear (Premium Display Only) • Stall protection
Over-temperature protection of drive motor, pump motor, and the control panel
Brake fluid level
Fault Code Display Sequence

When the truck key is switched off, the display shows truck hours, drive motor hours, and pump motor hours for four seconds each. At this point the mode buttons can be used to activate a display sequence of faults that caused the forklift truck to shut down. For details see instrument panels sections for both standard and premium displays.