Case 110, 115, 120, 130, 140 Maxxum EP Tractor Repair Manual

Manuals: Service Manual
Introduction
Engine
Clutch
Transmission
Four Wheel Drive 4WD
Front Axle System
Rear Axle System
Power Take Off (PTO)
Brakes and Controls
Hydraulic Systems
Hitches, drawbars and implement couplings
Frames and ballasting
Steering
Wheels
Cab Climate Control
Electrical System
Platform, cab, bodywork and decals
Special Tool Index
Manual Extract: Differential
Prior operation:
Assemble the differential, for further information refer to Differential – Assemble (25.102)
1. Clean and degrease the mating surfaces and apply a bead of gasket sealer approximately 2 mm wide along the mating surface as indicated.
NOTE: It is advisable that new seals are installed to avoid any leakages after assembly.
2. Install a suitable lifting eye bolt (1) to the pinion shaft.
Attach suitable lifting equipment (2) to the lifting eye bolt.
3. Install the differential into the axle housing, making sure that the 2 locating dowels are located correctly.
4. Install the differential housing securing bolts and tighten to 137 Nm (101 lb ft).
5. Using suitable lifting equipment, reposition the front axle on the axle stands.
Next operation:
Install the axle shafts, for further information refer to Axle shaft – Install (25.108)