Case SV212, SV216 Vibratory Rollers Repair Manual

Manuals: Service Manual
Introduction
Engine
Power Coupling
Hydrostatic drive
Brakes and Controls
Hydraulic System
Frames and Ballasting
Steering
Wheels
Cab Climate Control
Electrical System
Manual Extract: HYDRAULIC INSTALLATION

The hydraulic system controls all main functions of the machine. The power unit drives hydraulic pumps and supplies hydraulic pressure to the hydraulic motors which convert this form of energy into kinetic energy.

Distribution through the machine is assured by pipes and pressure hoses. Other controlling, regulating and safety components are installed in the circuit.
Electro valves, safety and control valves, hydrostatic locks.
The hydraulic system consists of the following circuits: • Hydraulics for travel + hydraulic regulators • Hydraulics for vibration
Hydraulics for control
Hydraulics for lifting
Hydraulic reservoir
DIAGRAM OF THE HYDRAULIC CIRCUITS
Hydraulic circuit connection is identical in both circuits.
Differences are only in the types of the pumps and hydraulic motors used.
The SV212 machine uses a 90r042 pump and 90m042 hydraulic motor for vibration.
The SV216 machine uses a 90r055 pump and 90m055 hydraulic motor for vibration.

Further differences are in the adjustment of a control pressure by-pass valve in the body of the vibration pump, where on the SV212 its pressure is set to 42 bar (609 psi), and on the SV216, 28 bar (406 psi).

Control pressure setting in the bodies of travel pumps is identical in both cases – 22 bar (319 psi). Operation of the individual closed circuits or their parts is described in detail in the following part.