Case 821F, 921F Wheel Loader Repair Manual

Manuals: Service Manual

Content

Introduction

Engine

Four Wheel Drive System

Front Axle

Rear Axle

Hydrostatic Drive

Brakes and Controls

Hydraulic System

Frames and Ballasting

Steering

Cab Climate control

Electrical System

Front Loader and Bucket

Platform, Cab, Bodywork and Decals

Special Tool Index

Manual Extract: Cab climate control – Air conditioning

Air Louvers

1. Make sure louvers and recirculation vents are fully open for most efficient air conditioning operation. Defrost louvers must be closed.

2. Check blower; blower must be running.

Air Conditioning

NOTICE: Use caution when feeling hoses. Hoses become very hot. Check temperature by slowly reaching for hose and touching briefly several times with finger tips, increasing the duration with each touch.

1. Feel the air conditioning hoses. The high pressure hoses (small line) must be warmer than the low pressure hose (large line).

2. If no temperature difference, the system is low on refrigerant, or compressor is not working correctly.

Duct Temperature

1. Put a thermometer in the air duct behind the seat and run the compressor for five minutes to make temperature stable.

2. Duct temperature must be below 25 °C (77 °F) if the system is operating at maximum efficiency.

3. If temperature is above 25 °C (77 °F), system is low on refrigerant, there is a restriction in the system, compressor is not working correctly, or air ducts are not sealed correctly.”

NOTE: Ambient temperature must be 27 – 43 °C (81 109 °F).