Case 570NXT Loader Repair Manual

Model: Case 570NXT
Manuals: Service Manual

Manual Table of Content:

Introduction
Engine
Four Wheel Drive System
Front Axle
Rear Axle
Hydrostatic Drive
Brakes and Controls
Hydraulic System
Hitches, draw bard and implement couplings
Frames and Ballasting
Steering
Wheels
Cab Climate control
Electrical System
Front Loader and Bucket
Platform, Cab, Bodywork and Decals
Special Tool Index
Electronic Schematics
Hydraulic Schematics
Manual Extract: Transmission drive and driven shafts – Inspect Oil pump
1. Inspect the large gear and the small gear for wear and damage. If the teeth on a gear have scoring, excessive wear, or sharp edges, use a new gear.
Check for damage to the lugs on the large gear. If there is damage, check the hub on the torque converter for similar damage. Replace the large gear and the torque converter as necessary.
2. Inspect the gear pockets in the pump housing for wear or damage. If the gear pockets have scoring or excessive wear, use a new oil pump.
3. Inspect the splines on the shaft for wear and damage.
If you find damage, inspect the part that is installed on the shaft.
4. Inspect all passages to be sure that the passages are open and free of foreign material.
5. Check the needle bearing for wear, pitting, or other damage.
6. Inspect the parts of the torque converter relief valve and the oil pump relief valve for wear and damage.
Identify the Tier Level of your Equipment (Read our Article on Tier Level )