Case 570N EP Wheel Loader Repair Manual

Manuals: Service Manual
Introduction
Engine
Transmission
Front Axle
Rear Axle
Power Take Off (PTO)
Hydraulic System
Hydraulic System
Wheels
Cab climate control
Electrical System
Front Loader and Bucket
Platform, Cab, Bodywork and Decals
Electrical Schematic
Hydraulic Schematic
Manual Extract: Transmission drive and driven shafts – Disassemble Primary shaft
1. Put the primary shaft on the bench so that the end with the bearing attached is up. Remove the snap ring.
2. Install a bearing separator under the gear as shown.

DO NOT install the bearing separator between the gear and the bearing. Install an acceptable puller on the bearing separator. Use a shaft protector between the puller and the end of the primary shaft. Use moly disulfide grease to lubricate the shaft protector and the end of the puller. Pull the bearing from the primary shaft.

3. Remove the bearing.
4. Remove the thrust washer.

5. Install a bearing separator under the lip of the bearing race as shown. Install an acceptable puller on the bearing separator. Use a shaft protector between the puller and the end of the primary shaft. Use moly disulfide grease to lubricate the shaft protector and the end of the puller. Pull the bearing race from the primary shaft.