Case CX240C Crawler Excavator Repair Manual

Manuals: Service Manual

Content

Introduction

Engine

Hydraulics System

Frames and Ballasting

Tracks and Track Suspension

Cab Climate Control

Electrical System

Booms, dippers and buckets

Platform, cab, bodywork and decals

Special Tools Index

Hydraulic Schematics

Electrical Schematics

Manual Extract: Turbocharger assembly installation

1. Install the turbocharger assembly on the exhaust manifold.

Tightening torque: 52 N·m (38 lb ft)

NOTICE: The specifications of the turbocharger vary with the manufacturer of the machine.

2. Install the exhaust pipe adapter on the turbocharger assembly.

Tightening torque： 32 N·m (24 lb ft) No.5 in the diagram

1. Exhaust manifold

2. Turbocharger assembly

3. Exhaust pipe adapter

3. Install the water feed pipe (1) on the cylinder block.

NOTICE: Use a new gasket.

Tightening torque: 41 N·m (30 lb ft) eyebolt.

Tightening torque: 24 N·m (18 lb ft) clip.

4. Install the water return pipe (1) on the water pump assembly.

NOTICE: Use a new gasket.

Tightening torque: 35 N·m (26 lb ft) eyebolt

Tightening torque: 24 N·m (18 lb ft) clip

Tightening order

5. Connect the water return pipe to the turbocharger assembly.

Tightening torque: 35 N·m (26 lb ft) eyebolt

1. Water return pipe

6. Install the oil return pipe on the flywheel housing.

NOTICE: Use new gaskets.

Tightening torque: 22 N·m (16 lb ft) 7. Connect the oil return pipe to the turbocharger assembly.

NOTICE: Use new gaskets.

Tightening torque: 9 N·m (6.64 lb ft) 8. Refill the turbocharger assembly with engine oil.

NOTICE: Inject clean engine oil (about 15–20 cm³ through the oil feed port.