Case CX210D Crawler Excavator Repair Manual

Manuals: Service Manual
Introduction
Engine
Hydraulics System
Frames and Ballasting
Tracks and Track Suspension
Cab Climate Control
Electrical System
Booms, dippers and buckets
Platform, cab, bodywork and decals
Special Tools Index
Hydraulic Schematics
Electrical Schematics
Manual Extract: Exhaust gas temperature (EGT) sensor installation
1. Clean the old anti-seize lubricant on the sleeve nut, and apply new anti-seize lubricant to the threaded portion of the sleeve nut.
2. Apply anti-seize lubricant to the EGT sensor.
NOTE: Apply High Temperature Stainless Never- Seez: 5-87411-039-0, manufactured by Bostik in the U.S., etc. to the threaded portion of the EGT sensor.
3. Temporarily tighten the EGT sensor to the oxidation catalyst assembly.

NOTICE: Do not subject the tip of the exhaust gas temperature sensor to shock when installing. Replace the oxidation catalyst assembly if damage has been found in the sensor installation section of the oxidation catalyst assembly.

NOTICE: To avoid damaging the sensor installation sections due to sensor incorrect assembly, tighten it by hand.
4. Final tighten the EGT sensor to the oxidation catalyst assembly.
Tightening torque: 30 N·m (22.1 lb ft)
5. Connect the harness connector to the exhaust gas temperature sensor.
NOTICE: Be careful not to twist the harness.
6. Start the engine after assembling each part, and check for gas leaks from each joint and for vibration.