BT Reflex RR BE, RR BE CC Reach Trucks Repair Manual

Publication 232808-040
English 2006
BT Reflex RR BE, RR BE CC Reach Truck Manual
Reach Truck Model: See below

Reach Truck Manual Table of Content:

General product information
Technical data
Maintenance
Oil and Grease
Drive unit
Brake
Display
Hydraulic
Wheels
Steering
Electrical
Assembling the transmission
Assembling the steering bearing (16): Fit the steering bearing (16) using the 15 hexagon socket bolts (19) on the drive transmission (17) with LOCTITE 242, to a torque of 25 Nm.
Always replace the lift valve (20) when the steering bearing has been removed or when fitting a new bearing.
Attach the new drive transmission (17) to the cowl (15). Oil the bolts (18) and tighten them to a torque of 80 Nm.
Secure the drive wheel, torque 130 Nm.
Insert the drive transmission (17) into position on the truck.
Fasten the drive transmission (17) with its cowl (15) to the chassis with the 6 bolts (14), torque 222 Nm.
Fit new O-rings and, if necessary, new plastic seals on the steering motor.
Fit the steering motor (12) on the drive transmission cowl; the tightening torque on the screws (11) should be 40 Nm.
Connect the contacts to the steering motor (10).
If the truck is equipped with a steering wheel indicator: Turn the steering wheel until an edge is visible through the hole for the centred steering indicator (8).
Screw in the centred steering indicator (8) so that it bottoms on the edge. Then turn it back 1 1/2 turns and lock it in place with a lock nut.
Screw in the steering wheel direction indicator (9) (red indicator diodes towards the battery compartment) until it stops, then turn it back 1 1/4 turns and lock it in place with a lock nut.