John Deere TeamMate V 1400 Series Inboard Planetary Axles Component Technical Manual (CTM143819)

Table of Contents (Component Technical Manual – CTM143819)
Section 01—General Information
Group 000—Safety
Group 005—General
Section 02—Repair and Adjustments
Group 010—Axle Oscillation Support
Group 020—Axle Repair Stand
Group 030—Input Housing
Group 040—Final Drive
Group 050—Planetary Carrier
Group 060—Single Disk Service Brake
Group 070—Differential Case Components
Section 03—Theory of Operation
Group 100—Axle Operation
Section 04—Diagnostics
Group 200—Brake Inspection, Adjustments, Tests, and Bleeding
Group 210—Operational Checks
Group 220—Troubleshooting
Group 230—Differential and Axle Tests
Section 05—Tools and Other Materials
Group 300—Special Tools
Group 310—Lubricants, Sealants, and Other Materials
Section 06—Specifications
Group 400—Bolt and Cap Screw Specifications
Group 405—Recommended Torque
Group 410—Sealants and Adhesives Cross-Reference
Use this component technical manual in conjunction with the machine technical manual. See the-machine technical manual for information on component removal and installation, and gaining access to-the components.
Information is organized in groups for the various components requiring service instruction. At the-beginning of each group are summary listings of all applicable essential tools, service equipment and-tools, other materials needed to do the job, service parts kits, specifications, wear tolerances, and-torque values.
This component covers the recommended repair procedure for the Teammate V 1400 Series Inboard Planetary Axles.
Some components from these axles, such as axle housings, brakes, and input quills, may be serviced-without removing the complete axle assembly from the machine. You may have to determine this
procedure yourself for a safe removal of such components. See information to remove and install the-complete axle assembly, found in your vehicle technical manual.