John Deere 6076 Natural Gas Engines (S.N after 500000 – ) Technical Manual (CTM82)

Table of Contents (Component Technical Manual – CTM82)
Safety
General Information
Fuel, Lubricants and Coolant
Engine Mounting
Engine Rebuild Guide
Cylinder Head and Valves
Cylinder Block, Liners, Pistons and Rods
Crankshaft, Main Bearings and Flywheel
Camshaft and Timing Gear Train
Lubrication System
Cooling System
Air Intake and Exhaust System
Fuel System
Ignition System and Electronic Governor
Engine Tune-Up and Break in
Engine System Operation and Test
Air Intake System Operation and Test
Fuel System Operation and Test
Ignition System Operation and Test
Engine Diagnostic
Dealer Fabricated Tools
These are divided as per the table of content. Repair sections tell how to repair the components. Diagnostic sections help you identify the majority of routine failures quickly.
This manual was planned and written for the Service Department; its place is in the shop. Use the manual whenever in doubt about correct maintenance procedures. Use it as a text book for training new Service Department personnel who are unfamiliar with John Deere Tractors.
The engine serial number plate is located either on the right-hand side of engine between the oil conditioning housing and fuel injection pump (viewed from flywheel end) or on the left-hand side of the block directly above the starting motor.
This component technical manual covers the recommended repair procedure for 6076, 7.6 L (466 cu. in.) natural gas engines produced in Waterloo, Iowa beginning with Engine Serial No. (500000— ). Before beginning repair of an engine, clean the
engine and mount on a repair stand. (See Group 03 – Engine Mounting.) Direction of engine crankshaft rotation in this manual is referenced from the flywheel end looking toward the front. Front of engine is fan drive end. Read each module completely before performing any service.